Raw material thickness: 2.5-3.0 mm

Sheet material: Q 235

Raw material width:482mm

1. Feeding

  1.1 single-head uncoiler, unilateral feeding

  1.2 the inside automaticly hydraulic swelling

  1.3 max coil volume weight:5000KG

  1.4 max coil diameter:2200mm

  1.5 hydraulic pump power: 3KW

  1.6 pump diameter:120mm, running pressure 10Mpa

  1.7 max coil width:500mm

2. Roll forming

  1.1 uncoiler and run into the guide pulley

  1.2 checking level: there are seven rollers working on it, three on the top and four on the bottom. The diameter of the forming shaft is Φ80mm(the shaft material is 45# after thermal refining). The material of the rollers is GCR15, hardening to HRC 58-62, plating hard chrome and supress thickness 2.5-3.0m

  1.3 punch: use the hydraulic punching device (Cr12 die steel hardening, and adjustable around freely)

  1.4 cutting: hydraulic press shearing( the material is Cr12 get hardening HRC 60-62)

  1.5 the main machine power: 18.5 KW

  1.6 Planetary gear speed reducer power: 15 KW

  1.7 dirve: 2" single side chain drive

  1.8 coil width:482mm

  1.9 hydraulic station motor power: 15 KW, pressure 20 Mpa

  2.0 the main machine adopts the speed governing 5-12m/min

  2.1 the computer use the PLC control system

  2.2 diameter:17500mm*1200mm*1500mm

3. discharge

   simple discharge table:

  3.1 this discharge table is weld by60mm*40mmsquare tube

  3.2 this table adopts movable pulley